Symbols On The Product; Product Liability - Husqvarna 236R Manual De Usuario

Ocultar thumbs Ver también para 236R:
Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 29
5. Shaft
6. Start throttle button
7. Stop switch
8. Throttle control
9. Throttle lockout
10. Suspension ring
11. Cylinder cover
12. Starter rope handle
13. Fuel tank
14. Choke control
15. Air filter cover
16. Handlebar
17. Clutch cover
18. Locknut
19. Support flange
20. Support cup
21. Drive disc
22. Handlebar clamp
23. Operator's manual
24. Transport guard (not for all markets)
25. Socket wrench
26. Wrench
27. Locking pin (for products without hex key)
28. Harness
29. Air purge bulb
30. Guard extension
31. Trimmer head
32. Hex key
33. 2-teeth blade

Symbols on the product

WARNING: This product can be dangerous
and cause serious injury or death to the
operator or others. Be careful and use the
product correctly.
Read the operator's manual carefully and
make sure that you understand the
instructions before use.
Use a protective helmet in locations where
objects can fall on you. Use approved
hearing protection and approved eye
protection.
Maximum speed of the output shaft.
The product agrees with the applicable EC
directives.
The product can cause objects to eject,
which can cause injury.
1395 - 002 - 14.01.2020
Keep a minimum distance of 15 m / 50 ft. to
persons and animals during operation of the
product.
Risk of blade thrust if the cutting equipment
touches an object that it does not
immediately cut. The product can cut off
body parts. Keep a minimum of 15 m / 50 ft.
distance to persons and animals during
operation of the product.
The arrows shows the limit for the handle
position.
Choke.
Air purge bulb.
Use approved protective gloves.
Use heavy-duty slip-resistant boots.
Noise emission to the environment refer to
the European Community's Directive. The
emission of the product is specified in the
Technical data chapter and on the label.
The rating plate shows the serial
yyyywwxxxx
number. yyyy is the production year
and ww is the production week.
Note: Other symbols/decals on the product refer to
certification requirements for other commercial areas.

Product liability

As referred to in the product liability laws, we are not
liable for damages that our product causes if:
the product is incorrectly repaired.
the product is repaired with parts that are not from
the manufacturer or not approved by the
manufacturer.
the product has an accessory that is not from the
manufacturer or not approved by the manufacturer.
the product is not repaired at an approved service
center or by an approved authority.
3

Publicidad

Tabla de contenido
loading

Tabla de contenido