To Assemble The J-Handle; To Assemble The Cutting Equipment - Husqvarna BCA850 Manual De Usuario

• Remove the battery before you do maintenance,
other checks or assemble the product.
• The operator must only do the maintenance and
servicing shown in this operator's manual. Turn to
your servicing dealer for maintenance and servicing
of a larger extension.
• Do not clean the battery or the battery charger with
water. Strong detergent can cause damage to the
plastic.
• If you do not do maintenance, it decreases the life
cycle of the product and increases the risk of
accidents.

To assemble the J-handle

WARNING: The J-handle shall be attached
to the loop handle if you intend to use the
product with any of the metal cutting
attachments recommended.
1. Attach the J-handle to the loop handle with 3 screws.
2. Adjust the product to a comfortable position.
3. Tighten the screws.
1340 - 001 - 20.12.2019
• Special training is necessary for all servicing and
repair work, especially for the safety devices on the
product. If not all checks in this operator's manual
are approved after you have done maintenance, turn
to your servicing dealer. We guarantee that there are
professional repairs and servicing available for your
product.
Assembly
To install the harness support hook if
applicable
1. Install the harness support hook between the arrows
on the rear handle and the loop handle.
Note: Do not put the loop handle on the decal.
2. Adjust the ring to make the product balanced, and
easy to use.

To assemble the cutting equipment

The cutting equipment includes a cutting attachment and
a cutting attachment guard.
WARNING: Use protective gloves.
WARNING: Always use the cutting
attachment guard that is recommended for
the cutting attachment. See
on page 12 .
WARNING: An incorrectly attached cutting
attachment can result in injury or death.
Technical data
7