To Assemble The Cutting Equipment; To Install The Cutting Attachment Guard And The Grass Blade; To Install The Harness Clamp - Husqvarna 128LX Manual Del Usuario

1. Put the J-handle between the 2 arrows on the shaft.
2. Install the screw, the plate and the wing nut.
3. Adjust the J-handle to a good work position.
4. Tighten the wing nut fully.

To install the harness clamp

WARNING: The harness must be attached
safely to the harness clamp when you
operate the product.
1. Put the 2 halves of the harness clamp onto the shaft
and align the screw holes.
2. Install the 2 screws.
3. Adjust the harness clamp to the correct position
above the arrow.
4. Tighten the 2 screws fully.
12

To assemble the cutting equipment

The cutting equipment includes a cutting attachment and
a cutting attachment guard.
WARNING: Use protective gloves.
WARNING: Always use the cutting
attachment guard that is recommended for
the cutting attachment. See
page 24 .
WARNING: An incorrectly attached cutting
attachment can result in injury or death.
To install the cutting attachment guard and the
grass blade
1. Put the cutting attachment guard (A) onto the shaft
and tighten the bolt.
2. Turn the output shaft to align one of the holes in the
drive disc (B) with the related hole in the gear
housing.
3. Put the locking pin (C) in the hole to lock the shaft.
4. Put the grass blade (D), the support cup (E) and the
support flange (F) on the output shaft.
D
C
A
Accessories on
A
G
F
E
B
1570 - 001 - 14.10.2020