Safety Instructions For Maintenance; Assembly; To Assemble The Shaft; To Adjust The Harness - Husqvarna 115iPT4 Manual De Usuario

• Do not put objects into the cooling slots of the
battery charger.
• Do not connect the battery charger terminals to
metal objects as this can short circuit the battery
charger.
• Use approved mains sockets that are not damaged.
Make sure that the cord of the battery charger is not
damaged. If extension cables are used, make sure
that the extension cables are not damaged.

Safety instructions for maintenance

WARNING: Read the warning instructions
that follow before you do maintenance on
the product.
• Remove the battery before you do maintenance,
other checks or assemble the product.
Introduction
WARNING: Read and understand the safety
chapter before you assemble the product.

To assemble the shaft

1. Make sure that the electrical plugs are aligned.
A
2. Connect the ends of the shaft (A) fully.
3. Tighten the screw handle on the saw head side of
the shaft (B).
707 - 003 - 04.03.2019

Assembly

B
• The operator must only do the maintenance and
servicing shown in this operator's manual. Turn to
your servicing dealer for maintenance and servicing
of a larger extension.
• Do not clean the battery or the battery charger with
water. Strong detergent can cause damage to the
plastic.
• If you do not do maintenance, it decreases the life
cycle of the product and increases the risk of
accidents.
• Special training is necessary for all servicing and
repair work, especially for the safety devices on the
product. If not all checks in this operator's manual
are approved after you have done maintenance, turn
to your servicing dealer. We guarantee that there are
professional repairs and servicing available for your
product.
• Only use original spare parts.
To adjust the length of the shaft
1. Loosen the screw handle at the battery housing side
of the shaft (A).
A
2. Adjust the shaft to an applicable length.
3. Tighten the screw handle (B).

To adjust the harness

Always use the harness when you operate the product.
The harness gives maximum control during operation of
the product. The harness decreases the risk of tiredness
in your arms and back.
1. Put on the harness.
2. Attach the product to the harness support hook.
B
11