Kroeplin IP 67 Manual De Instrucciones página 35

Program: TOL
Configuration tolerance ranges: Example tolerance range 3 / Adjusting the tolerance limit –
Example: 10,00 ±0,1mm in the „Absolute – Mode"
Activating the SETUP – Menu in the
„Absolute – Mode"
1x long
„tOL" will appear in the display
2x short
"1" for tolerance range 1 will appear in the display
1x long
The last selected status will appear in the display / Factory setting: 1
Switch to tolerance range "3"
2x short
„tOL LO" will appear in the display for 2s
1x long
The last saved lower tolerance value will appear.
Selecting the next digit
1x short
Reducing the digit
1x short
Selecting the next digit
1x short
Reducing the digit
1x short
For confirming and saving
1x long
„tOL UP" will appear in the display for 2s
The last saved upper tolerance value will appear.
Adjusting lower tolerance limit (9,90mm)
35