Intended Use; Technical Data - Scheppach RT2300-Li18V Manual De Instrucciones Original

debris.
• The user is responsible for accidents or injuries to other
people.
• After finishing the work, turn off the device and remove
the battery.
• Do not use the charger if it is damaged.
• Use the device only with batteries and chargers intended
for it. Using other components can lead to fire.
Safety notices for the charger
• Keep the charger away from rain and wet condi-
tions. Water ingress into the charger increases the risk
of an electric shock.
• Keep the charger clean. Dirt increases the risk of
an electric shock.
• Before every use, check the charger, cable and
plug. Do not use the charger if you notice any
damage. Do not open the charger yourself but
have it repaired exclusively by qualified special-
ists and only with original spare parts. Damaged
chargers, cables and plugs increase the risk of electric
shock. Do not place objects on the charger and do not
put the charger on soft surfaces. Risk of fire
• Always check if the mains voltage corresponds
with the voltage specified on the rating plate of
the charger.
• Never use the charger if the cable, plug or the
charger itself have been damaged by external
influences. Take the charger to the nearest specialist
service centre
• Do not open the charger under any circum-
stances. In the event of a fault, take it to a specialist
service centre.
Safety notices for Li-Ion batteries
• Do not open the battery. Risk of short-circuiting!
• Protect the battery from heat, e.g. from constant
sun exposure, and from fire, water and humidity.
Risk of explosion.
• When the battery has been damaged or it is
being used inappropriately, fumes can be re-
leased. Let fresh air in and consult a doctor if the fumes
cause you any problems. The fumes can irritate the res-
piratory tract.
• Only use original batteries with the voltage
specified on the rating plate of your power tool.
If other batteries are used, e.g. imitations, reconditioned
batteries or products from third party manufacturers,
there is a risk of personal injury as well as property dam-
age based on exploding batteries.
• The battery voltage must correspond with the
battery charging voltage of the charger. Other-
wise, there is a risk of fire and explosion.
• Charge the batteries only in chargers that have
been recommended by the manufacturer. There
is a risk of fire if a charger for a particular type of battery
is used for another type of battery.
The battery can be damaged by sharp objects
such as a nail or screwdriver or by external ap-
plication of force. The battery may short-circuit and start
burning, smoking, exploding or overheating.
Warning! This electric tool generates an electromagnetic
field during operation. This field can impair active or pas-
sive medical implants under certain conditions. In order
to prevent the risk of serious or deadly injuries, we rec-
14 І 56
 www.scheppach.com  service@scheppach.com  +(49)-08223-4002-99  +(49)-08223-4002-58
ommend that persons with medical implants consult with
their physician and the manufacturer of the medical im-
plant prior to operating the electric tool.

Intended use

The equipment is designed for cutting lawns and small areas
of grass in private and hobby gardens. Equipment designed
for use in private and hobby gardens is regarded as unsuit-
able for use in public facilities, parks and sports centers,
along roadways, or in agriculture and forestry. The operat-
ing instructions as supplied by the manufacturer must be
kept and referred to in order to ensure that the equipment
is properly used and maintained.
Important. This equipment must not be used for
composting purposes (shredding) as this could
result in injury or damage to property.
The equipment may be used only for the tasks it is designed
to handle. Any other use is deemed to be a case of misuse.
The user/operator and not the manufacturer will be liable
for any damage or injuries of any kind resulting from such
misuse.
Please note that our equipment has not been designed for
use in commercial, trade or industrial applications. Our
warranty will be voided if the equipment is used in com-
mercial, trade or industrial businesses or for equivalent
purposes.
Remaining hazards
The machine has been built using modern technology and
in accordance with recognized safety rules.
Some hazards, however, may still remain.
• Wear regulation safety gear such as safety boots and
tight work clothing.
• Electrical hazards exist when unsuitable electric con-
nections are used.
• Although having regarded all considerable rules there
may still remain not obvious remaining hazrds.
• Minimize remaining hazards by following the instruc-
tions in "Safety Rules", "Use only as authorized" and in
the entire operating manual.

Technical data

Nominal voltage
Speed n
0
Cutting circle diameter of line
Cutting line diameter
Weight (without battery)
Noise and vibration
18 V
8000 min
-1
230 mm
1,2 mm
1,85 kg