Speedrite FAULT FINDER Manual De Uso página 5

9 Hold the handset within 150 mm (6") of the energizer then press
transmit the address to the energizer.
A moving arrow appears on the handset's display. The energizer's LED indicator
lights (and LCD, if fitted) display the address setting. The energizer then goes
into Standby mode with only the green light on the right flashing. After a few
seconds, the handset will automatically switch itself off.
10 Test that the energizer is obeying commands from the handset (see
whether the energizer is obeying commands from the handset
To exit the handset's setup menu without setting the energizer and handset's address
setting:
Instead of pressing
Enabling the energizer's remote control feature where a
handset has been supplied as a separate accessory and is not
an additional or replacement handset
Follow the steps for
handset
above. If this works, do not proceed any further. If this doesn't work, follow
these instructions:
1 Energizers with a selector switch - Connect the energizer to a power source.
Slide the energizer selector switch to Off. Wait for 15 seconds, then switch the
energizer to one of the On positions.
Other energizers - Disconnect the energizer from the mains/line power source.
Wait for 5 minutes, then reconnect energizer to the power source.
Note: You must set the energizer and handset's address setting within four
minutes of the energizer being switched back on or reconnected to the power
source.
2 Press and hold
3 Press repeatedly to scroll through the list of setup options until you get to
the Address (Ad) option.
4 Press repeatedly to scroll through the list until you get to the desired
address setting (any address setting between 1-15).
5 Hold the handset within 150 mm (6") of the energizer then press
transmit the address to the energizer.
A moving arrow appears on the handset's display. The energizer's LED indicator
lights (and LCD, if fitted) display the address setting. The energizer then goes
into Standby mode with only the green light on the right flashing. After a few
seconds, the handset will automatically switch itself off.
6 Test that the energizer is obeying commands from the handset (see
whether the energizer is obeying commands from the handset
To exit the handset's setup menu without setting the energizer and handset's address
setting:
Instead of pressing
in step 9, press
Configuring and testing system supplied with energizer and
, then press
in step 4, press
. This switches off the handset.
to enter the handset's setup menu.
. This switches off the handset.
to
Testing
below).
to
Testing
below).