Speedrite FAULT FINDER Manual De Uso página 6

Configuring an additional or replacement handset
Your energizer and original handset's address settings are set to a number (1-15). You
need to change the new handset's address setting to match.
1 Determine the energizer's address setting (see
address setting
2 Press and hold
3 Press repeatedly to scroll through the list of setup options until you get to
the Address (Ad) option.
4 Press repeatedly to scroll through the list until you get to the desired
address setting (the address setting you found in step 1).
5 Press .
A moving arrow appears on the handset's display. After a few seconds, the
handset will automatically switch itself off.
6 Test that the energizer is obeying commands from the handset (see
whether the energizer is obeying commands from the handset
To exit the handset's setup menu without setting the handset's address setting:
Instead of pressing
Identifying the energizer's address setting
Energizers with an LCD display
When the energizer is first switched on, the LED indicator lights show a light sequence
for two seconds identifying the address setting of the energizer. The address setting is
also shown on the LCD display together with the letters 'Ad'.
Other energizers
When the energizer is first connected to the power source, all the LED indicator lights
illuminate. They then illuminate separately from left to right and back again. This
indicates that the energizer is operating normally. The LED indicator lights then show a
light sequence for three seconds, displaying the address setting of the energizer.
To identify the energizer's address setting, match what you see on the energizer's
display with one of the following illustrations.
below).
, then press
in step 5, press
Identifying the energizer's
to enter the handset's setup menu.
. This switches off the handset.
Testing
below).
Address
1
2
3
4
5