Replacing The Battery - Speedrite FAULT FINDER Manual De Uso

Disabling or enabling the backlight
To disable or enable the backlight (bL):
1 Press and hold
2 [bL] will now be flashing.
or off.
3 Do one of the following:
- To disable the backlight, press
- To enable the backlight, press
4 Press to store the setting.
5 Press to switch off the handset.

Replacing the battery

When you see on the screen, the battery needs replacing.
To replace the battery:
1 Unscrew the case back.
2 Unclip the old battery, and replace with a new PP3, 9 V, alkaline battery.
3 Screw the case back into place, taking care not to trap the battery leads under
the screws or in the case assembly.
Caring for the handset
•
Do not leave the handset in direct sunlight, for instance on a vehicle dashboard.
•
Use only a damp cloth to clean the handset.
•
If the handset gets wet, wipe it dry and place it face down to allow any water to
run out of the speaker grill. The handset is water-resistant and should require no
further attention.
Troubleshooting
The energizer does not respond to commands from the handset
•
Check that your energizer is suitable for use with a handset (see your distributor
for advice).
•
Ensure that the Remote contact is in contact with the fence wire before pressing
or
from the display, as the energizer may send out a final pulse after receiving the
signal to deactivate. Similarly, allow two seconds for the energizer to send out
its first pulse after receiving the command to reactivate.
•
If the symbol is displayed on the handset, replace the 9 V alkaline battery and
try again.
, then press
now acts as a toggle to switch the backlight on
. Wait for two seconds for the ON or OFF message to disappear
to enter the handset's setup menu.
until OFF appears on the screen.
until ON appears on the screen.