Manual Tuning - Aiwa NSX-V50 Manual De Instrucciones

1
BAND
9
MANUAL TUNING
1
2
Press the TUNER/BAND button to select the band
repeatedly.
m
If the power is turned off, the previously tuned station will be
played (Direct Play Function).
Press the 1+ DOWN or W UP button to select
a station.
Each time the button is pressed, the frequency changes.
When a station is received, "TUNE is displayed for 2 seconds.
During FM stereo reception, {([~]))is displayed.
To search for a station quickly (Auto Search)
Keep the M DOWN or EM UP button pressed until the tuner
starts searching for a station. After tuning in to a station, the
search stops.
To stop the Auto Search manually, press the M DOWN or ~
UP button.
The Auto Search may not stop at stations with very weak
signals.
When an FM stereo broadcast contains noise
Press the MONO TUNER button to display "MONO" on the
display. +
Noise is reduced, although reception is monaural.
To restore stereo reception, press the button so that MONO
disappears.
To change the AM tuning interval
The default setting of the AM tuning interval is 10 kHz/step. If
you use this unit in an area where the frequency allocation system
is 9 kHz/step, change the tuning interval.
Press the POWER button while pressing the TUNER/BAND
button.
To reset the interval, repeat this procedure.
m
When the AM tuning interval is changed, all preset stations (see
page 22) are cleared. The preset stations have to be set again.
20