REPT
UNKNOWN CALLER
WAITING HANDSET
REGISTRATION
Handset Sound Signals
Signal
A long warbling tone (with ringer on)
Three short beeps
One short beep (every 7 seconds)
Troubleshooting Guide
Telephone Solutions
No dial tone
• Check and repeat installation steps:
Ensure the base power cord is connected to a working outlet .
Ensure the telephone line cord is connected to the base and the wall jack.
• Connect another phone to the same jack; if there is still no dial tone, the
problem might be your wiring or local service.
• The cordless handset may be out of range of the base. Move closer to the
base.
• Ensure the battery is properly charged (16 hours).
• Ensure the battery pack installed correctly.
42
Repeat call message. Indicates that a new call
from the same number was received more
than once.
The incoming call is from an area not serviced by
Caller ID or the information was not sent.
Prompt telling you to enter registration mode
of handset.
Meaning
Signals an incoming call
Page signal
Low battery warning