Yamaha AV-S77 Manual De Instrucciones página 34

OPERATING OTHER COMPONENTS USING THE REMOTE CONTROL
I Precautions when performing the
setting
You can operate the component using the TV, VCR or DVD
operation buttons on the remote control once the
manufacturer code is set properly. If unsuccessful, perform
the procedure from step 1 again. Pay attention to the
following points when you perform the procedure.
• Check that the correct remote control selector button has
been selected when setting the manufacturer code.
• If more than one code is given for a manufacturer, try
entering each code in the order given.
• Remove and replace the remote control's batteries
(complete this step within 2 minutes) and then perform
the procedure. While replacing the batteries, be sure not
to press any button on the remote control. Doing so may
erase the manufacturer code which has been set for other
remote control selector buttons.
I To reset the manufacturer code to
the factory-set code
Follow steps 1 to 2 for the procedure "Setting the
Manufacturer code", and enter "11" while pressing CODE
SET in step 2. (It is not necessary to follow step 3.)
32
E-