Troubleshooting Guide - Shark NV351 Manual De Instrucciones

Troubleshooting Guide

PROBLEM
Vacuum is not
picking up dirt.
Vacuum lifts scatter rugs
(lightweight, movable
rugs).
Airflow is restricted. No
suction or light suction.
Brush roll does not spin
Vacuum turns off on its
own.
To purchase replacement parts, please visit our website: www.sharkclean.com
NV351_26_NV352_26_IM_ENG_SPA_101207.indd 17
POSSIBLE REASONS & SOLUTIONS
Check filters to see if they need cleaning. Follow instructions for rinsing
and drying the filters before re-inserting back into the vacuum. (See
"Maintenance" sections for instructions.)
Dust cup may be full; empty dust cup.
Check hose and hose connections for blockages; clear blockages if required.
If dust cup is empty, and attachment inlets are clear, check for other
blockages. (See "Checking for Blockages" for instructions.)
Suction is powerful. Take care when vacuuming scatter-type rugs or rugs
with delicately sewn edges. Open the suction release on the handle to
decrease suction power.
Move the On/Off switch to "I - Suction Only" position to disengage the
brush roll
Check filters to see if they need cleaning. Follow instructions for rinsing and
drying the filters before re-inserting back into the vacuum.
Dust cup may be full; empty dust cup.
Check hose, hose connections, nozzles and accessories for blockages; clear
blockages if required.
Close the suction release on the handle to increase suction power.
If dust cup is empty, and attachment inlets are clear, check for other
blockages.
Immediately turn off and unplug vacuum, disconnect the nozzle and remove
blockage before reconnecting and turning vacuum back on.
Pull the handle toward you and release the floor nozzle to disengage the
auto-off feature.
Move the On/Off switch to the "II - Brush Roll On" position.
This vacuum cleaner is equipped with a motor protective thermostat. If for
some reason your vacuum overheats, the thermostat will automatically turn
the unit off. Should this occur, perform the following steps to restart the
motor thermostat:
1. Move the On/Off switch to the "O" (Off) position.
2. Unplug the vacuum.
3. Empty the dust cup and clean filters.
4. Check for blockages in hose, accessories and inlet openings.
5. Allow the unit to cool for a minimum of 45 minutes.
6. Plug in the vacuum.
7. Turn the On/Off switch to the "I" (On) position to restart the vacuum.
Note: If vacuum still does not start, contact Customer Service at:
1-800-798-7398.
or contact customer service: 1-800-798-7398.
www.sharkclean.com
10-12-08 9:32 AM
English
17