Bissell 2215 SERIE Manual De Instrucciones página 5

Assembly
WARNING
Do not plug in your vacuum until you are familiar with all instructions and operating
procedures.
1
Insert upper handle into vacuum base.
Attach with the screw that is taped to
the handle.
3
Snap lower cord wrap to the lower back
of unit. Wrap the vacuum cord.
5
Slide TurboEraser® Tool Holder into place
on the front of the vacuum where the
handle meets the vacuum base. Place
TurboEraser® Tool into tool holder.
5
Remove the pre-motor filter and replace
with the Febreze™ Filter. Place top back
on tank, line arrow with the unlock
graphic and twist left to lock in place.
2
Push handle end into the base of
vacuum on the opposite side.
4
Place crevice tool (inside extension
wand) and extension wand onto the
lower cord wrap base.
6
To install the optional Febreze™ Filter,
press the tank release button and pull
container from vacuum. Twist top of the
tank right to unlock and remove.
www.BISSELL.com
5