Sulion Serie 072217 Manual De Instrucciones página 19

HOW TO SET UP LEARNING MODE IF MULTIPLE
FANS ARE INSTALLED IN THE SAME HOUSE
If the end user owns more than one ceiling fan in the same room/household,
read this instruction manual and follow the steps carefully to connect each fan with
its respective handheld remote controller.
1
Turn off the main power
to all the fans.
5.Wait for at least 3 minutes after setting up the learning mode for the first fan.
The receiver will lock this code automatically within these 3 minutes.
6.Connect the power supply to the second fan and repeat steps 1-6 for the second
fan. While programming the second fan, keep the power supply on for the first fan.
7.Please follow the steps above to set up the learning mode for your other fans.
NOTE:
There are 67,000 different codes (combinations) of learning modes.
When you set up the learning mode for a fan, the receiver will randomly pick a code.
The possibility of choosing the same code is minimal.
Please note that if you have more than one fan in close proximity, different ceiling
fans can be controlled by one handhold remote controller using the universal mode.
IMPORTANT: Learning mode will not work for fans that are controlled
by the same wall switch.
2
UPPER
Downwards
DIP switches
Remove the handheld
remote controller
battery cover.
Place both DIP
switches in the
downwards position.
You may use a test
pen to move the
switches.
3
Turn on the power
supply to the fan you
are programming. The
fan will beep for 4
seconds.
6
4
BEEP
Within 30 seconds after
the beeping sound,
press and hold the
"SET" button for 4
seconds. Once the
receiver has detected
and learned the
frequency, the receiver
will beep again.
This means the
self-learning process is
complete and the fan
is ready to use.
BEEP
SET
SET