Auto Flush Function (Option) - Grohe 39354SH0 Manual Del Usuario

Auto Flush Function (OPTION)
*This function is only available for the GROHE tank equipped with auto-flush function.
Flushes the toilet automatically, approximately 6 seconds by default, after the user stands up from the toilet.
You can also change this flush delay setting.
1. Press the
(set/next) button repeatedly until the [SETTING1] screen appears.
2. Press the button below [AUTO FLUSH] repeatedly to select the setting.
[2 sec]: Flushes after 2 seconds
[6 sec]: Flushes after 6 seconds (Default)
[10 sec]: Flushes after 10 seconds
[15 sec]: Flushes after 15 seconds
[OFF]: Auto flush function is off
NOTE:
In the event that water service to the toilet is interrupted, fill a bucket with water and carefully pour
the contents into the toilet bowl to manually flush the toilet. Repeat if necessary.
When too much toilet paper is used, it may not be flushed completely when the
button is used. In this case, press the
Continuous flushing may not be possible. If this happens, flush the toilet manually by pressing the
/
buttons or flush button on the wall after a while.
Auto flush function will not activate when the user seats on the toilet for less than 10 seconds.
Top > How to Use > Settings > Auto Flush Function (OPTION)
(flush/full) button.
86
(flush/light)