Cleaning The Exterior; Troubleshooting - Dremel Idea Builder 3D40 Instrucciones De Funcionamiento

DM 2610039151 01-16_3D40 1/7/16 9:33 AM Page 33
UPDATING FIRMWARE VIA NETWORK
If your 3D40 is registered and added to your
Dremel3D profile, you can update its
firmware directly from the touchscreen. To
update firmware:
1. Tap "Tools", "Settings", "Check for
Updates".
2. Your 3D40 will check to see if it has the
latest firmware installed and ask if you
would like to update if one is needed.
3. Choose accept to download and install the
latest firmware.
4. When the 3D40 starts up and returns to
the Home Screen, firmware update is
complete.
UPDATING FIRMWARE MANUALLY
If your 3D40 is not connected to a network,
you can update firmware directly from a USB
Flashdrive.
1. On your web
www.dremel3d.com/support and download
the latest 3D40 firmware file.
browser go to
33
2. Add the 3D40 firmware file to an empty,
FAT32 formatted, USB flashdrive.
3. Turn off your 3D40 using the ON/OFF
switch.
4. Insert the USB flashdrive into the USB-A
port.
5. Turn on your 3D40 and it should
automatically detect and install the new
firmware.
6. Turn your 3D40 OFF, remove the USB
flashdrive, and turn ON again to complete
the update.

CLEANING THE EXTERIOR

Clean the 3D40's exterior with a lint free
cloth. Clear the outer surfaces of any debris
that is visible.
To avoid damaging your Dremel 3D40 do not
use water, chemicals or other cleaners on
the 3D40.
CLEANING THE EXTRUDER TIP
Use extra care not to
damage the extruder tip
CAUTION
when clearing debris. Dremel 3D40 will not
work properly with damaged extruder tip and
will require replacement.
Do not touch the extruder
tip during Dremel 3D40
WARNING
operation or until it has cooled down to
60°C (140°F). Contact with the extruder tip
during or after operation before tip has
cooled may result in personal injury.
Using small needle nose pliers, pull away
any plastic debris from the extruder tip.
If the debris is stubborn, the extruder may
need to be heated.
CLEANING THE TOUCH SCREEN
Wipe the touch screen with the soft, lint-free
cloth. Do not spray cleaners on the touch
screen.