Maintenance; Cleaning The Exterior - Dremel 3D45 Instrucciones De Funcionamiento Y Seguridad

DM 2610047405AB 03-18_3D45 3/27/18 9:51 AM Page 34
34
UPDATING FIRMWARE VIA NETWORK
If your 3D45 is registered and connected to
WiFi, it should check for firmware updates
each time it boots up. You can also update its
firmware directly from the touch screen. To
update firmware:
1. Tap "Tools", then tab "Updates".
2. Your 3D45 will check to see if it has the
latest firmware installed and ask if you
would like to update if one is needed.
3. Choose accept to download and install the
latest firmware.
4. When the 3D45 starts up and returns to
the Home Screen, firmware update is
complete.
UPDATING FIRMWARE MANUALLy
If your 3D45 is not connected to a network,
you can update firmware directly from a USB
flash drive.
1. On your web
www.digilab.dremel.com and download
the latest 3D45 firmware file.

Maintenance

browser go to
2. Add the 3D45 firmware file to an empty,
FAT32 formatted, USB flash drive.
3. Turn off your 3D45 using the ON/OFF
switch.
4. Insert the USB flash drive into the USB-A
port.
5. Turn on your 3D45 and it should
automatically detect and install the new
firmware.
6. Turn your 3D45 OFF, remove the USB
flash drive, and turn ON again to complete
the update.

CLEANING THE ExTERIOR

Clean the 3D45's exterior with a lint free
cloth. Clear the outer surfaces of any debris
that is visible.
To avoid damaging your Dremel 3D45 do not
use water, chemicals or other cleaners on
the 3D45.
CLEANING THE ExTRUDER TIP
Use extra care not to
damage the extruder tip
CAUTION
when clearing debris. Dremel 3D45 will not
work properly with damaged extruder tip and
will require replacement.
Do not touch the extruder
tip or heated build platform
WARNING
during Dremel 3D45 operation or until it
has cooled down to at least 60°C (140°F).
Contact with the extruder tip or build platform
during or after operation before tip and build
plate has cooled may result in personal injury.
Using small needle nose pliers, pull away
any plastic debris from the extruder tip.
If the debris is stubborn, the extruder may
need to be heated.
CLEANING THE TOUCH SCREEN
Wipe the touch screen with the soft, lint-free
cloth. Do not spray cleaners on the touch
screen.