Engine Oil - Husqvarna PP 418 Manual De Instrucciones

FUEL HANDLING
WARNING
Taking the following precautions will lessen the risk
of injury and property damage:
• Use extreme care in handling gasoline. It is extre-
mely fl ammable and the vapors are explosive.
• Extinguish all cigarettes, cigars, pipes, and other
sources of ignition.
• Use only approved gasoline containers.
• Never remove gas cap or add fuel with the engine
running. Allow engine to cool a minimum of 3 mi-
nutes before refueling.
• Never fuel the machine indoors.
• Never store the machine or fuel container where
there is an open fl ame, spark, or pilot light such as
on a water heater or other appliances.
• Never fi ll containers inside a vehicle or on a truck
or trailer bed with a plastic liner. Always place
containers on the ground away from your vehicle
when fi lling.
• Remove the power pack from the truck or trailer
and refuel it on the ground. If this is not possible,
then refuel the equipment with a portable contai-
ner, rather than from a gasoline dispenser nozzle.
• Keep the nozzle in contact with the rim of the fuel
tank or container opening at all times until fueling
is complete. Do not use a nozzle lock-open device.
• If fuel is spilled on clothing, change clothing im-
mediately.
• Never overfi ll fuel tank. Always wipe off any spilled
fuel or oil. Replace fuel cap and tighten
PROPER FUEL
The BRIGGS & STRATTON engine is certifi ed to operate on
unleaded gasoline with a pump octane rating (M+R) of 86
or higher, or a research octane rating (R) of 91 or higher.
Refuel in a well-ventilated area with the engine stopped.
You may use regular unleaded gasoline containing no more
than 10% ethanol (E10). Do not use gasoline containing
methanol.
Use of fuels with an ethanol content of more than 10%
(E10) may cause starting and/or performance problems. It
may also damage metal, rubber, and plastic parts of the
fuel system, as well as posing a fi re hazard.
Do not use fuel that is older than 30 days. Old fuel can
cause running problems as well as fuel system damage.
The engine will not operate on gasoline marketed as
E-85 (85% ethanol)
8
OIL HANDLING
NOTICE
Used oil is a hazardous waste product. Dispose of
used oil properly. Do not discard with household
waste. Check with your local authorities, service cen-
ter, or dealer for safe disposal/recycling facility.

ENGINE OIL

Oil Recommendation
The engine holds approximately 1.4 liters (1-1/2 qts - 48
ounces) when changing oil and oil fi lter.
• Use a high quality detergent oil classifi ed "For Service
SF, SG, SH, SJ" or higher.
• BRIGGS & STRATTON strongly recommends the use of
Synthetic oil.
• Do not use special additives.
• Choose a viscosity according to the table below.
Use of synthetic oil does not alter required oil change
intervals.
Please read the enclosed BRIGGS & STRATTON
Operator's Manual for complete oil information.
SAE VISCOSITY GRADES
5W-30
SYNTHETIC OIL 5W-30, 10W-30
-20 0 30
F
C -30 -20 -10
TEMPERATURE RANGE ANTICIPATED BEFORE NEXT OIL CHANGE
OIL HANDLING
Any high quality hydraulic oil with a viscosity rating of ISO
46 (46 cSt) can be used.
High quality hydraulic oils that are marketed as "Biode-
gradable" can be used with a viscosity rating equivalent of
ISO 46.
NOTE: Biodegradable hydraulic fl uids may require different
service intervals compared to the traditional mineral based
oils. Consult and follow the oil manufacturers recommen-
dations regarding the service life of the oil.
The Hydraulic system is also compatible with some "Food
Grade" oils that can be used for specifi c applications.
Please contact Husqvarna Construction Products for ad-
vice.
SAE 30
32 40 100
60 80
0 10 20 30 40