Assembly - Husqvarna PP 418 Manual De Instrucciones

NOTICE
The PP 418 power pack must be serviced before use.
In some markets the power pack will be delivered fi l-
led with both engine oil and hydraulic oil.
Remove the power pack from its shipping material and
place it on a level surface.
CAUTION
Only use the lifting eyelet when lifting the power
pack.
Step 1
Check the engine oil level. If no oil is present on the dip-
stick add oil in accordance to the recommendations on
page 8 or consult the BRIGGS & STRATTON Operator's
Manual.
Step 2
Fill the hydraulic oil tank. Use only a high quality hydraulic
oil – ISO 46. See page 8 for other alternatives. The total
fi rst time oil amount needed is 10 liters (2.6 gal) to fi ll the
tank. The oil should be fi lled to the middle of the sight
glass.
The oil level must be rechecked and refi lled after the initial
test running has been done - see page 12.

ASSEMBLY

Step 3
Hook up the hydraulic hoses to the power pack. Connect
the two couplers in the free end of the hose. The hoses are
now ready to be charged with oil from the oil tank.
NOTE: The hoses can be installed with either end to the
power pack. Any set of hoses assembled with the coup-
lers as in this illustration will always have full compatibility
between power pack, hoses and tool.
If the hydraulic hoses (7.5 m/25 ft) are empty they will
require approximately 1.8 liters (2 quarts) of additional oil
to be added to the oil tank after running the power pack for
the fi rst time.
If an additional 30 m (100 ft) of 5/8" hose set is used they
will require approximately 12 liters (3.2 gal) to be added.
The oil level in the oil tank must be rechecked several times
when fi lling a new hose set.
Step 4
Check the tire pressure. The wheels are tubeless. If the tire
pressure becomes too low the wheel will defl ate comple-
tely. Infl ate to 2 bar (30 psi)
Step 5
The power pack is delivered without the battery cables
installed to the battery. Please read; SERVICING THE BAT-
TERY on page 10.
The original equipment battery is maintenance free. Do
not attempt to open or remove caps or covers. Adding or
checking the level of electrolyte is not necessary.
Lead-acid batteries generate explosive gases. Keep
sparks, fl ame and smoking materials away from
batteries. Always wear eye protection when around
batteries.
Step 6
Fill the fuel tank with fresh clean gasoline. See warnings
and recommendations on page 8. Add only fuel in a quanti-
ty that will be used within 30 days to assure fuel freshness.
If the power pack is stored with fuel in the tank for longer
periods we recommend to use a commercially available
"Fuel Stabilizer".
WARNING
9