Bosch SRV53C Manual De Uso Y Cuidado página 12

Adding Detergent and Rinse Agent
Opening the Detergent Dispenser
Cover
NOTE : To open the detergent dispenser
cover, press the blue release in the direction
shown in Figure 12. Pressing down on the
release tab will not open the cover.
Press the blue release tab in the direction shown
by the arrow in Figure 12.
The cover will
slide open to
the right.
Filling the Rinse Agent Dispenser
Open the rinse agent dispenser by pressing the
cover with your index finger while lifting the tab
with your thumb as shown in Figure 13.
Add liquid rinse agent to the dispenser as shown
in Figure 14 until the rinse agent reservoir is full.
Wipe up any excess rinse agent that puddles
when the dispenser reservoir is full.
10
Figure12
Figure 13
Figure 14
(continued)
Return the rinse agent dispenser cover to its shut
position and press it firmly so that the cover
snaps shut.
Refill the rinse agent dispenser when the Refill
Rinse Agent indicator "
control panel.
NOTE : After filling the rinse agent dispenser, the
Refill Rinse Agent Indicator will go out in a few
minutes after the dishwasher door is shut.
Rinse Agent Dispenser Regulator
The amount of rinse agent dispensed can be
regulated to control spotting and streaking. The
Rinse Agent Dispenser Regulator as shown in
Figure 15 leaves our factory set at 4.
To adjust the amount of rinse agent
dispensed:
1. Open the rinse agent dispenser cover.
2. If your dishes are streaked after washing,
turn the regulator to a lower number.
3. If your dishes are spotted after washing,
turn the regulator to a higher number.
Figure 15
Turn dial to adjust the
amount of rinse agent
dispensed
" illuminates on the