Assembly; To Attach The Wheel Kit (Accessory); To Replace The Drill Stand Column (Assessory); To Attach The Drill Motor - Husqvarna DS 500 Manual Del Usuario

Introduction
This section describes how to assemble and adjust the
product.
WARNING: Before you assemble the
product, read the safety chapter and the
assembly instructions.

To attach the wheel kit (accessory)

1. Attach the wheel kit on the rear side of the bottom
plate.
2. Tighten the screw.

To attach the drill motor

WARNING: Always pull out the plug from the
outlet socket before cleaning, maintenance
or assembly.
1. Unlock the drill motor carriage (A).
2. Attach the drill motor in the track (B) on the drill
motor carriage.
3. Lock the drill motor carriage (A).
A
B
Quick spacer (accessory)
Use a quick spacer to drill large hole diameters. To
select the correct quick spacer, refer to
6

Assembly

diameter on page 13 . Assemble the quick spacer on
the drill motor before you attach the drill motor to the drill
stand.
To replace the drill stand column
(assessory)
1. Push the stop plate to open position. Remove the
Maximum drill
drill motor carriage.
922 - 002 - 06.03.2019