Secure The Stand; Fixing With Expander Or Anchor; Fixing With Threaded Rod, Washer And Lock Nut; Assembly Of Drill Motor - Husqvarna DS900 DD Manual De Instrucciones

Ocultar thumbs Ver también para DS900 DD:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Secure the stand

There are two methods for fixing the stand.

Fixing with expander or anchor

Fixing with threaded rod, washer and lock nut

Fixing with expander or anchor
IMPORTANT! When drilling ceilings and
!
walls, only expander or anchor suitable
for surfaces exposed to tensile forces
should be used.
Use only expander or anchor which is
approved for current application.
Drill a hole for the expander/anchor at a distance (A),
400 mm (15,7") from the centre of the hole. (The
measurement applies for use together with DM 650
without spacer.)
A
Screw on the base plate. Check carefully that the
expander is secured correctly.
The base plate can be adjusted to the surface with the
adjustment screws.
NOTICE! It is a good idea to use the front of the track
(closest to the column).
OPERATING
Fixing with threaded rod, washer and lock
nut
If the mounting surface is inadequate for drilling in ceilings
or walls, the base plate can be fixed using a threaded rod,
which is mounted on the backside with a washer and lock
nut.

Assembly of drill motor

!
Always remove the drill bit before the motor is
mounted or dismounted.
Lock the feed housing lock.
Fit the drilling machine in the track on the locking
clamp. Make sure that the drilling machine is pushed
all the way to the bottom (A) of the track on the locking
clamp. Fasten the locking clamp with the locking
screw (B).
B
Mount the adapter plate on the drill motor if it is
needed. Not used with Husqvarna's drill motors.
IMPORTANT! Always pull out the plug
from the outlet socket before cleaning,
maintenance or assembly.
A
English
9

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Ds900

Tabla de contenido