Maintenance; To Adjust The Drill Motor Carriage; Daily Maintenance; To Clean And Lubricate The Product - Husqvarna DS900 Manual De Usuario

1. Loosen the lock screw that locks the drill column and
set the applicable drill angle.
Introduction
WARNING: Read and understand the safety
chapter before you do maintenance on the
product.
WARNING: To prevent injury, disconnect the
power cord before you do maintenance.

Daily maintenance

• Make sure that the nuts and screws are tight.
• Clean the external surfaces.
• Make sure that the feed lever moves without
resistance.
• Make sure that the gears move easily and do not
cause a noise.
• Examine the drill column for wear and damage.
• Make sure that the drill motor carriage moves easily
and that there is no play against the drill column.

To clean and lubricate the product

CAUTION: If you do not clean the drill stand,
it can become damaged.
10
a) Use the angle indicator for approximate
adjustment. If higher precision is necessary, use
alternative methods to measure.
2. Tighten the lock screw of the drill column.

Maintenance

1. Remove the drill motor.
2. Clean the product with a high-pressure washer and
then remove remaining water with a dry cloth.
3. Lubricate the moving parts of the product. Apply
grease to the contact surfaces to prevent corrosion.

To adjust the drill motor carriage

If there is distance between the drill column and the drill
motor carriage, the drill motor carriage must be
adjusted.
1324 - 001 - 11.10.2019