Tips To Help You Save Energy; Advice On Disposal; Troubleshooting - Siemens TS22 Serie Instrucciones De Uso

Tips to help you
save energy
Steam production consumes the most energy. To
help minimise the energy used, follow the advice
below:
• Start by ironing the fabrics that require the
lowest ironing temperature.
Check the recommended ironing temperature
in the label on the garment.
• Regulate the steam according to the selected
ironing temperature, following the instructions
in this manual.
• Try to Iron the fabrics while they are still damp
and reduce the steam setting. Steam will be
generated from the fabrics rather than the iron.
If you tumble dry your fabrics before ironing
them, set the tumble drier on the 'iron dry'
programme.
• If the fabrics are damp enough, turn off the
steam regulator completely.
Trouble shooting
problem
Pilot light (12*) flashes Boiler and filter must be rinsed.
The steam generator
does not come on.
The iron does not heat
up.
The iron begins to
smoke when switched
on.
20
S I E ME NS
possible causes
• There is a connection problem.
• The main power switch is not
switched on.
• The main power switch is not
switched on.
• The temperature is set to a low
position.
• During first use: certain components
on the appliance have been lightly
greased at the factory and may
produce a little smoke when initially
heated.
• During subsequent use: the
soleplate may be soiled.

advice on disposal

Our goods come in optimised packaging. This
basically consists in using non-contaminating
materials which should be handed over to the
local waste disposal service as secondary raw
materials. Your local town council can give you
information about how to dispose of obsolete
appliances.
This appliance is labelled in
accordance with European Directive
2012/19/EU concerning used
electrical and electronic appliances
(waste electrical and electronic
equipment - WEEE).
The guideline determines the
framework for the return and
recycling of used appliances as applicable
throughout the EU.
Solution
Rinse the filter and the boiler according to
the cleaning instructions in this manual
(see section E).
• Check the mains cable (6), the plug and
the socket.
• Set the main power switch (13) to the "I"
position.
• Set the main power switch (13) to the "I"
position.
• Set the temperature to the desired
position.
• This is completely normal and will stop
after a short while.
• Clean the soleplate according to the
cleaning instructions in this manual.