Publicidad
T EC HN I C A L INF O RM AT IO N
Water pressure
recommended
maximum
Hot water temp.
recommended
maximum
Flow rate @ 44 PSI
* Please know and follow all applicable local plumbing
codes when setting the temperature on the water
heater.
I N STALL ATI ON CO N SI DE R AT I ON S
⁄ For best results, Hansgrohe recommends that
this unit be installed by a licensed, professional
plumber.
⁄ Please read over these instructions thoroughly
before beginning installation. Make sure that you
have all tools and supplies needed to complete
the installation.
⁄ This product is for use with shower heads rated at
1.1 GPM (4.2 L/min) or higher.
⁄ This trim is for use with iBox Universal Plus model
01850181 (not included).
T H E ROTAT IO N A L L I M IT STOP (S E E PAG E 19)
Adjust the rotational limit stop if:
⁄ The maximum output temperature is greater than
120°F (49°C) or that permitted by local plumb-
ing code
⁄ The temperature of the incoming hot or cold
water supply changes seasonally, or if changes
are made to the water heater.
2
15 - 75 PSI (0.1-0.5 MPa)
145 PSI (1 MPa)
120°-140° F (49°- 60°C)*
176°F (80° C)*
5.5 GPM (20.8 l/min)
E N G L I S H
⁄ To prevent scald injury, the maximum output tem-
perature of the shower mixing valve must be no
higher than 120°F (49°C). In Massachusetts, the
maximum output temperature can be no higher
than 112° F (44°C).
⁄ Keep this booklet and the receipt (or other proof
of date and place of purchase) for this product in
a safe place. The receipt is required should it be
necessary to request warranty parts.
Publicidad
