•
Change the engine oil, and discard the waste oil.
•
Empty the fuel tank. Start the engine and run it until
there is no remaining fuel in the carburetor.
Note: Do not empty the fuel tank and carburetor if a
stabilizer has been added.
•
Remove the plugs and put about a tablespoon of
engine oil into each cylinder. Manually turn the
engine shaft to apply the oil and put the plugs back
on.
•
Lubricate all grease nipples, joints and axles.
•
Keep the product in a clean and dry area and cover
it for more protection.
•
A cover for protection of your product during storage
or transport is available at your dealer.
Disposal
•
Chemicals can be dangerous and must not be
discarded on the ground. Always discard used
chemicals at a service center or an applicable
disposal location.
•
When the product is worn out, send it to the dealer
or to an applicable recycling location.
•
Oil, oil filters, fuel and the battery can have negative
effects on the environment. Obey the local recycling
requirements and applicable regulations.
•
Do not discard the battery as domestic waste.
•
Send the battery to a Husqvarna service agent or
discard it at a disposal location for used batteries.
32
838 - 005 - 21.10.2019