Velleman VMM502 Manual Del Usuario página 13

Step 2 – Pre-Coding
Refer to Project 1, Step 3 – Pre-Coding.
Step 3 – Coding
 Click on Tinkercademy
in your kit.
 Next, let's create a code as shown in the picture. For this project, no initialisation is required and there
isn't much code anyway.
First, drag and drop the logic function
block if then else
Next, add the motion detector at pin
block. The blocks snap together. The block
in the Tinkercademy
V. 01 – 17/01/2019
inside the Code Drawer to find our custom blocks for the various components
if then else
can be found in the Logic
P0
in Code Drawer.
VMM502
in the code editor under the
in Code Drawer.
detects motion block next to the
motion detector at pin
13
forever block. The
if logic. Replace the
P0 detects motion can be found
©Velleman nv
true