Replacing The Heating Element; Technical Specifications - Velleman VTSS100 Manual Del Usuario

4.1 SOLDERING
1. Connect the station to the mains. Note that the automatic cooling function has started.
2. Switch on the unit. The heating element reaches its ideal temperature.
3. Set the temperature (± 300-350 °C) and the airflow (1-3).
4. Apply some solder paste onto the IC.
5. Preheat the IC.
6. Solder the IC onto the PCB by heating the lead frame evenly.
7. Wash away the flux when soldering is completed.
NOTE: Be very careful not to damage the IC when soldering. Examine soldering conditions sufficiently.
4.2 DESOLDERING
1. Connect the unit to the mains by means of the power cord and switch on the unit. Upon connection,
the automatic blowing function will start blowing air through the pipe. The heating element remains
cool.
2. Switch on your station. The heating element warms up.
3. Set the temperature (± 300-350 °C) and airflow (1-3).
4. Melt the solder. Hold the gun in such way that the nozzle be directly over the IC. Be careful not to
touch any leads of the IC.
5. Remove the IC using tweezers.
6. Turn off the power to the unit.
5.

Replacing the Heating Element

CAUTION: Disconnect the unit from the mains prior to examining and maintaining. Failure to
do so may result in electroshocks.
1. Loosen the two screws and slide out the heating element. Be careful not to drop the quartz glass or
the heating element.
2. Disconnect the terminal and remove the heating element.
3. Insert a new heating element and reconnect the terminal. Reconnect the ground wire. Handle the
heating element with great care.
4. Reassemble the handle.
6.

Technical Specifications

power supply .................................................................................... 230 V~, 50 Hz
power consumption .......................................................................................250 W
temperature range ................................................................................ 100-500 °C
heating element .......................................................................... metal heating core
with diaphragm pump
air capacity ............................................................................................. 23 L/min.
dimensions station ................................................................... 188 x 127 x 244 mm
total weight .............................................................................................. 2.675 kg
Use this device with original accessories only. Velleman nv cannot be held responsible in the
event of damage or injury resulting from (incorrect) use of this device. For more info
concerning this product and the latest version of this manual, please visit our website
www.velleman.eu. The information in this manual is subject to change without prior notice.
© COPYRIGHT NOTICE
The copyright to this manual is owned by Velleman nv. All worldwide rights reserved. No part
of this manual may be copied, reproduced, translated or reduced to any electronic medium or otherwise
without the prior written consent of the copyright holder.
V. 04 – 03/08/2017
VTSS100
3 ©Velleman nv