Hot surface indicator
•
Comes on when the unit is turned on or hot to the touch.
•
Stays on even after the unit is turned off.
•
Glows until the unit is cooled to approximately 150 °F.
Cooking areas
•
The cooking areas on your range are identified by permanent circles on the
glass cooking surface. For the most efficient cooking, fit the pan size to the
element size.
•
Pans should not extend more than ½" to 1" beyond the cooking area.
•
When a control is turned on, a glow can be seen through the glass cooking
surface. The element will cycle on and off to maintain the preset heat setting,
even at high settings.
•
For more information on selecting proper types of cookware, refer to the
section "Using the proper cookware" on page 20.
How to set the appliance for cooktop cooking
CAUTION
•
The surface elements may be hot and burns may occur. Do not touch the
surface elements until they have cooled down sufficiently.
At high or medium-high settings, never leave food unattended. Boilovers
•
cause smoking and greasy spillovers may catch on fire.
•
Be sure you turn the control knob to OFF when you finish cooking.
NE59M4320_DG68-00882A-04_EN+MES+CFR.indb 19
Surface unit control knob
2
1
Single
(Left rear, Right rear)
1.
Push the knob in.
2.
Turn in either direction to the setting you want.
•
Position A : Single burner
•
Position B : Dual burner
CAUTION
The area between the high and off settings is not appropriate for cooking.
Recommended settings
SETTING
HIGH
Starting most foods, bringing water to a boil, pan broiling
MEDIUM HIGH
Continuing a rapid boil, frying, deep fat frying
Maintaining a slow boil, thickening sauces and gravies,
MEDIUM
steaming vegetables
MEDIUM LOW
Keeping foods cooking, poaching, stewing
LOW
Keeping food warm, melting, simmering
2
A
B
1
Dual
(Left front, Right front)
TYPE OF COOKING
English 19
2019-02-01
12:43:36