Technical Characteristics; Diagnostics Led - tau D750M Guía Para La Instalación

The D750M panel features an electronic photocell control system which switches the external
photocell transmitter on and off thereby causing the control unit microprocessor to check wheth-
er the relay switches correctly. If this does not happen, the control unit is automatically blocked
• MICROPROCESSOR-CONTROLLED LOGIC
• SELF-DIAGNOSIS LED's
• LINE INPUT FUSE
• BUILT-IN TORQUE LIMITING DEVICE
• ELECTRONIC CONTROL OF SAFETY DEVICES
• PEDESTRIAN ENTRY FUNCTION
• BUILT-IN FLASHING LIGHT CIRCUIT
• 433.92 MHz 2 CHANNEL BUILT-IN RADIO RECEIVER (CH)
• "SLOW-DOWN" FUNCTION IN OPENING AND IN CLOSING PHASE
When all connections have been made:
 All the green LS LED's must be on (each corresponds to a Normally Closed input).
 They only turn off when the commands they are associated with are active.
 All the red LS LED's must be off (each corresponds to a Normally Open input) they only turn
on when the commands they are associated with are active.
Power input to board
Max motors nominal power
Primary input line rapid fuse (F1 - 5x20)
Input voltage of motor circuits
Input voltage of auxiliary circuits
24Vac line rapid fuse (F2 - 5x20)
Logic circuit input voltage
Working temperature
Box protected to
DL1 OPEN/CLOSE button red LED signal
DL2 PEDESTRIAN button red LED signal
DL3 STOP button green LED signal
DL4 SENSITIVE EDGE green LED signal
DL5 INTERNAL PHOTOCELL green LED signal
DL6 EXTERNAL PHOTOCELL green LED signal
DL7 RADIO CONTROLS programming red LED signal
16
CONTROL CARD FOR TWO SINGLE-PHASE MOTORS 230 Vac

TECHNICAL CHARACTERISTICS

D750M
English
TESTING
230Vac - 50Hz
600 W ca.
F 6,3 A
230 Vac
24 Vac
F 1,6 A
5 Vdc
-20°C ÷ + 70 °C
IP43

DIAGNOSTICS LED