Factory Reset The System; Reset A Source Button On The Remote Control; Service Connectors On The Acoustimass ® Module - Bose SoundTouch 130 Guia Del Propietario

Care and Maintenance

Factory reset the system

To troubleshoot problems, reset the System menu and the ADAPTiQ
calibration to the factory settings.
1. Press
2. Press until 16 FACTORY RESET appears on the display.
3. Press 5.
The system resets.
4.
Run the ADAPTiQ audio calibration (see page 21).

Reset a source button on the remote control

If you are experiencing problems with a source button on the remote control, reset
the source button to the factory settings.
After performing this procedure, your source button is in CEC mode.
1. On the remote control, press and hold the appropriate source button until all
six source buttons glow, then release.
Only the appropriate source button glows.
2. On the number keypad, enter 0140.
Service connectors on the Acoustimass
The Service and Data connectors are for service use only. Do not insert any cables
into these connectors.
38 - English
on the remote control.
audio
®
module
®