Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

!
I
I
ti
structi
as
Air Conditio
r_
Questions?
Call 800.GE.CARES {800.432.2737)
or Visit our Website
at: GEAppliances.com
In Canada, call 1.800.561.3344
or visit www.GEAppliances.ca
r
1
BEFORE YOU BEGIN
Read these instructions
completely
and carefully.
• IMPORTANT
- Save these
instructions
for local inspector's use.
• IMPORTANT
- Observe all governing
codes and ordinances.
• Note to Installer-
Be sure to leave these
instructions
with the Consumer.
• Note to Consumer
- Keep these instructions
for
future reference.
• Skill level - Installation
of this appliance
requires
basic mechanical
skills.
• Completion
time - Approximately
1 hour
. We recommend
that two people install this
product.
.
Proper installation
is the responsibility
of the
installer.
Product failure due to improper
installation
is not
covered under the Warranty.
You MUST use all supplied parts and use proper
installation
procedures
as described in these
instructions
when installing this air conditioner.
ELECTRICAL REQUIREMENTS
Some models require a 115/120-volt AC,
60-Hz grounded outlet protected with a
15-amp time-delay fuse or circuit breaker.
The 3-prong grounding plug minimizes the
possibility of electric shock hazard. If the wall outlet
you plan to use is only a 2-prong outlet, it is your
responsibility to have it replaced with a properly
grounded 3-prong wall outlet.
Some models require 230/208-volt AC,
protected with a time-delay fuse or circuit
breaker. These models should be installed
on their own single branch circuit for best
performance and to prevent overloading
house or apartment wiring circuits, which
could cause a possible fire hazard from
overheating wires.
CAUTION:
Do not, under any circumstances,
cut or remove
the third
{ground) prong from the power cord.
Do not change the plug on the power cord
of this air conditioner.
Aluminum
house wiring
may present
special
problems--consult
a qualified
electrician.
TOOLS YOU WILL NEED
Phillips head screwdriver
Flat-blade screwdriver
Pencil
Ruler or tape measure
Level
Scissorsor knife
Power cord includes a current interrupter
device. A test and reset button is provided on the
plug case. The device should be tested on a periodic
basis by first pressing the TEST button and then the
RESETbutton while plugged into the outlet. If the
TEST button does not trip or
if the RESETbutton will not stay engaged, discontinue
use of the air conditioner and contact a qualified
service technician.

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Ael06Ael08

Tabla de contenido