Akasa integral Manual De Usuario página 12

for Windows
Software installation
Windows Me / 2000 / XP
NOTE: enclosed CD driver disk is not required
for the installation
1.
When the USB External Drive is used for the
first time your PC system will detect a USB2.0
Storage Device and automatically install the
drivers for [USB Mass Storage Device]
the installed system files.
2.
When the PC system finishes installing the
USB mass storage device driver, double click
on [My Computer]. A drive Disk is added
after few seconds, this is the INTEGRAL LAN
drive.
NOTE:
This INTEGRAL LAN drive is supported by Mass Storage Device within WIN Me/2000/XP system directly.
You do not need to install any drivers. If the external hard disk is a new disk drive which has not been
partitioned, please refer to the Partition the External Hard Disk chapter
external disk.
Using the INTEGRAL LAN Device
After the first installation, you can connect or disconnect the INTEGRAL LAN device without powering
off the computer, please follow the steps when you want to do the above actions
Connecting the INTEGRAL LAN device
1. Connect the INTEGRAL LAN to your computer with the supplied USB cable.
2. Connect the AC power cable to an available AC socket and your INTEGRAL LAN. Switch on the
power, your INTEGRAL LAN is ready to use.
22
USB Connection
from
to prepare your USB2.0
for Windows
Windows 98SE
1.
Boot-up your computer into the Windows 98SE,
2.
Connect the INTEGRAL LAN to your computer with the supplied USB cable.
5.
[CD-ROM
To install the drivers, click the
click on [Next], and a screen should appear, this shows which Storage Devices you have installed, click
on [Next].
2
USB Connection
make sure the USB interface driver is installed.
.
If this is the first time you connect the INTEGRAL
LAN to your computer, the [Add New Hardware
Wizard] dialog box appears.
4.
Click on [Next], select the [Search for the best
driver for your device], and click on
drive], select the device driver CD into your CD-ROM drive,
[Next].