Akasa integral Manual De Usuario página 3

for Windows
Introduction
Congratulations on your purchase of the INTEGRAL LAN .5" hard disk enclosure. This User Manual is
intended to help you install the INTEGRAL LAN drive quickly and easily onto your Personal Computer or
Ethernet Network and begin using it immediately. INTEGRAL LAN drives are the perfect solution to your
network storage needs. Share documents, music, videos, and pictures with your family or coworkers through
your network. Simply connect the drive to your network, install our easy to use software and you're up and
running. Say goodbye to confusing network setups and configurations. With its Key Code security features,
your data is kept private from unauthorized access.
The INTEGRAL LAN drive works in both network mode as well as a standalone USB mode. Take advantage
of the ultra fast USB 2.0 transfer rates by connecting the INTEGRAL LAN drive directly to your PC's USB 2.0
port. With its portability, ease of use, high performance, and extra capacity, the INTEGRAL LAN drive has you
covered.
Package Contents
• INTEGRAL LAN enclosure
• USER Manual
• Software & Driver CD
• Power Adapter
• USB & Ethernet Cables
• Footstand
System Requirement
• Pentium III or Athlon processor 800MHz (1.2 GHz or faster recommended)
• Windows XP/2000/ME/98SE
• 128MB of RAM (256MB recommended)
• One Available USB 1.1 Port for USB mode (USB 2.0 recommended)
• CD-ROM drive for installation
• 100Base-T full duplex switch for Network mode
Features
• Support .5" IDE HDD (PATA)
• Shared network direct attached storage (NDAS) for your home or office
• Easy setup and installation
• Sleek & portable design
• USB 2.0 (USB 1.1 backwards compatible)
• Key Code security protection
• Driver supports Windows: XP/2000 (Network Mode)
• XP/2000/ME/98SE (USB Mode)
• Data transfer rates of:
Network mode: 100Mbit/sec
▎
USB mode: 480Mbit/second
▎
4
for Windows
Harddisk Installation
1.
Open the back of the enclosure by undoing
the securing screws and sliding the tray out
of the aluminium housing.
NOTE: Disconnect the LED cable before
completely sliding the HDD tray out .
POWER
CONNECTOR
IDE
CONNECTOR
LED
CABLE
3.
Place the HDD in the tray aligning the correct
IDE and power connectors. Then connect the
IDE and power connectors to the HDD.
5
Harddisk Installation
2.
Write down the ID number and KEY before
closing the enclosure. It is going to be needed
in later stages of the network installation.
4.
Position the HDD in the tray so that the
mounting holes on the HDD line up with the
tray mounting holes. Use the four screws
supplied in the mounting kit to secure the
HDD in the tray.