Connect Hose And Water Supply To Pump - Craftsman 580.752870 Instrucciones De Uso

Connect Hose and Water Supply to Pump
NOTICE DO NOT run the pump without the water supply
connected and turned on.
, Damage to equipment r esulting from failureto follow this
instructionwill voidwarranty,
4. Run water through garden hose for 30 seconds to flush
it of debris. Turn off water.
NOTICE DO NOTsiphon standing water for the water
supply. Use ONLYcold water (less than 100%).
5. Connectgarden hose (not to exceed50 ft. in length) to
water inlet. Tighten by hand.
NOTICE Remove and discard the shipping caps from the
pump's high pressure outlet and water inlet before attaching
hoses.
1. Uncoil high pressure hose and attach one end of hoseto
base of spray gun. Tighten by hand.
NOTICE Using a One Way Valve (vacuum breaker or check
valve) at pump inlet could cause pump or inlet connector
damage.
, ThereMUSTbe at bast tenfeet of unrestricted garden hose
between the pressure washerinletandanydevice,suchas a
vacuumbreaker o r checkvalve.
* Damageto equipment resulting from failure to follow this
instruction will void warranty.
WARNING The high pressure stream of water that
this equipment produces could cut through skin
and its underlying tissues, resulting in serious
injury and possible amputation.
, NEVER connecthighpressure hoseto nozzle extension.
* Keephigh pressure hoseconnected to pumpand spraygun
whilesystemis pressurized.
* Alwaysbe certainspraygun,nozzles andaccessories a re
correctlyattached.
.
Attach other end of high pressure hose to high pressure
outlet on pump. Tighten by hand.
t", %%
.
Before connecting garden hose to water inlet, inspect
inlet screen (A). Cleanscreen if it contains debris or have
it replacedif damaged. DO NOTrun pressurewasher if
inlet screen is damaged ar missing.
"_,:
.
WARNING Risk of eye injury.
Spray could splash back or propel objects
resulting in serious injury.
* Always wear indirect vented (chemical splash) safety goggles
marked to comply with ANSi ZSX1 when using or in vicinity of
this equipment.
* NEVERsubstitute safety glasses or dry=condition goggles for
indirect vented safety goggbs.
Turn on the water, press red button (l}) on the gun and
squeezethe trigger to purge the pump system of air and
impurities.
Checklist Befere Starting Engine
Reviewthe unit to ensure you have performed all of the
following:
1. Be sure to read Safety Rules and Operationsections
before using the pressure washer.
2. Make sure handle is in place and secure.
3. Checkthat oil has been added to proper level in engine
crankcase.
4. Add proper fuel to fuel tank.
5. Checkfor proper hose connections (high pressure
and water supply) and that there are no kinks, cuts, or
damageto the high pressure hose.
6. Provide proper water supply (not to exceed 100%).
11