Craftsman 580.752870 Instrucciones De Uso página 4

WARNENG Starter cord kickback (rapid retraction) wiUU
_1_ ull hand and arm toward engine faster than you
can let go which could cause broken
bones,
fractures, bruises, or sprains resulting
in serious
injury.
* NEVERpull starter cord without first relieving spray gun
pressure.
, When starting engine, puRR c ord showilyunfii resistance is feit
and then puRR r apNiy to avoid kickback.
, After each starting attempt, where engine faiB to run, aiways
point spray gun in safe direction, press red button and squeeze
spray gun trigger to reieasehigh pressure.
,Firmiy grasp spray gun with both hands when using high
pressure spray to avoid injury when spray gun kicks back.
A WARNING Risk of electrocution.
Contact with power source could cause electric
shock or burn resulting in death or serious injury.
* NEVERspray near power source.
_k WARNING The high pressure stream of water that
this equipment produces could cut through skin
and its underlying tissues, resulting in serious
injury and possible amputation.
Spray gun traps high water pressure, even when engine is
stopped and water is disconnected, which could result in
serious
injury.
. if cut by fluid, call physician immediately. DO NOTtreat as a
simple cut.
. DO NOT allow CHILDRENto operate pressure washer.
. NEVERrepair high pressure hose. Replaceit.
. NEVERrepair baking connections with sealant of any kind.
Replaceo-ring or seal.
. NEVERconnect high pressure hose to nozzle extension.
. Keep high pressure hose connected to pump and spray gun
while system is pressurized.
. DO NOTlift or tilt surface cleanerfrom horizontal surface while
connected to spray gun. Releasespray gun trigger prior to
lifting or tilting.
. ALWAYS point spray gun in safe direction, press red button
and squeezespray gun trigger to releasehigh pressure, every
time you stop engine.
° NEVERaim spray gun at people,animals, or plants.
. DO NOTsecure spray gun in open position.
. DO NOTleave spray gun unattended while machine is running.
. NEVERuse a spray gun which does not have a trigger lock or
trigger guard in place and in working order.
. Always be certain spray gun, nozzles and accessoriesare
correctly attached.
A WARNING Fuel and its vapors are extremely flammable
and explosive which could cause burns,
fire or explosion resulting in death or
serious injury.
WHENADDING OR DRNNING FUEL
, Turn pressure washer engine OFFand let it cool at bast 2
minutes before removing fuel cap. Loosen cap slowly to relieve
pressure in tank.
* Fill or drain fuel tank outdoors.
* DO NOT overfill tank. Allow spacefor fuel expansion.
° if fuel spills, wait until it evaporates before starting engine.
° Keepfuel away from sparks, open flames, pilot lights, heat, and
other ignition sources.
° Checkfuel lines, tank, cap and fittings frequently for cracks or
leaks. Replaceif necessary.
° DO NOT light a cigarette or smoke.
WHENSTARTINGEQUmPMENT
* Ensurespark plug, muffler, fuel cap, and air cbaner are in place.
* DO NOTcrank engine with spark plug removed.
WHEN OPERATINGEQUIPMENT
, DO NOToperate this product inside any building, carport,
porch, mobile equipment, marine applications, or enclosure.
, DO NOTtip engine or equipment at angle which causes fuel to
spiii.
, DO NOT spray fiammabb liquids.
WHENTRANSPORTING,MOVING OR REPAiRiNG EQUIPMENT
, Transport/move/repair with fuel tank EMPTYor with fuel shutoff
valve OFF(0).
. DO NOTtip engine or equipment at angle which causes fuel to
spill.
. Disconnect spark plug wire.
WHEN STORINGFUEL OR EQUIPMENTWiTH FUEL IN TANK
, Store away from furnaces, stoves, water heaters, clothes
dryers, or other appliancesthat have pilot light or other ignition
source becausethey could ignite fuel vapors.
A. WARNING Exhaust heat/gases could ignite
combustibles, structures or damage fuel
tank causing a fire, resulting in death or
serious injury.
Contact with muffler area could cause burns resulting in
serious injury.
° DO NOTtouch hot parts and AVOID hot exhaust gases.
° Allow equipment to cool before touching.
. Keep at bast 5 ft. (1.5 m) of clearanceon all sides of pressure
washer including overhead.
. it is a violation of California Public ResourceCode, Section
4442, to use or operate the engine on any forest-covered,
brush-covered, or grass-covered land unless the exhaust
system is equipped with a spark arrester, as defined in Section
4442, maintained in effective working order. Other states or
federal jurisdictions may havesimilar laws.
Contact the original equipment manufacturer, retailer, or dealer
to obtain a spark arrester designed for the exhaust system
installed on this engine.
. Replacement parts must be the same and installed in the same
position as the original parts.