Unpack The Pressurewasher; Attach Handle And Accessory Tray - Craftsman 580.752870 Instrucciones De Uso

Your pressure washer requires some assembly and is ready
for use only after it has been properly serviced with the
recommended oil and fuel.
_fyou have any problemswith the assembly of your
pressurewasher, please call the pressurewasher helpline
at 1o860o222o3136.
UNPACK THE PRESSUREWASHER
1. Remove everything from carton except pressure washer.
2. Open carton completely by cutting each corner from top
to bottom.
3. Remove pressure washer from carton.
CABTON CONTENTS
Check all contents, if any parts are missing or damaged, carl
the pressure washer helpline at 1-800-222-3136.
, Main Unit
, Handle
, Accessory Tray with Hose Wrap
, High Pressure Hose
, Spray Gun
, Nozzle Extensionwith Quick Connect Fitting
, Oil Pouch
, Bottle Bracket Wireform
, PerfectMixTM Siphoning Unit/Hose
, Parts Bag (which includes the following):
, Operator's Manual
, Owner's Registration Card
, Bag containing 4 Multi-Colored Quick Connect 8pray
Tips
, Handle FasteningHardware Kit (which includes):
, Handle Bolts (2)
° Carriage Bolt (1)
° Plastic Knobs for Handle(2_
° Plastic Knob (1)
o Tree Clips (4)
Become familiar with each piece before assembling the
pressure washer, identify all contents with the illustration
on page 6. if any parts are missing or damaged, call the
pressure washer helpline at 1-800-222-3136.
ASSEMgLINOPRESSURE WASHER
Your Craftsman pressure washer will need assembly before
operation:
1. Fill out and send in registration card.
2. Attach handle and accessory tray.
3. Connectdetergent siphon hose to pump.
4. Add oil to engine crankcase.
5. Add fuelto fuel tank.
6. Connect pressure hose to spray gun and pump.
7. Connectwater supplyto pump.
8. Attach nozzleextension to spray gun.
9. Select/attach quick connect spray tip to nozzleextension.
Attach Handle and Accessory Tray
1. Place handle (A) onto handle supports connected to
main unit. Make sure hobs in handle align with hobs on
handle supports.
_i I
2. insert handle carriage bolts (B) through hobs from
inside of unit and attach a plastic knob (C) from outside
of unit. Tighten by hand.
NOTICE By loosening both knobs to the middle section of
the attachment bolt, the upper handle can fold forward to
store fiat atop the cold engine. DONOTfold the handle down
while the engine is hot.
3. insert rubber straps (B) through slots (E) in back of
accessorytray and pull tight from front.