Conceptronic C54APM Manual De Inicio Rápido página 53

ENGLISH
3.2.7. Co nfiguration To
U se the "Backup" tool to save
"config.bin" on your PC. You c
configuration to the Access Po
D efault" tool to force the Acce
factory settings.
Click the Apply button at the ottom of the screen to save the above configurations.
3.2.8. Firm ware Upgrad
This tool allows you to upgra e the Access Point's system firmware. To upgrade the firmware
of your Access Point, you need to
the file name and path in the appropriate field on this page. You can also use the Browse
button to find the firmware
p rocess is complete.
Click the Apply button at the ottom of the screen to save the above configurations.
3.2.9. Res et
In the event that the system st
can perform a re set. Your set
Apply button. You will be aske
you may start using the Acces
Click the Apply button at the bottom of the screen to save the above configurations.
ol
the Acces s Point's current configuration to a file named
an use the "Restore" tool to upload and restore the saved
int. Alternatively, you can use the "Restore to Factory
ss Point to perform a power reset and restore the original
b
e
d
download the firmware file to your local hard disk, and enter
file on your PC. Please reset the Access Point when the upgrade
b
ops responding correctly or in some way stops functioning,
tings will not be changed. To perform the reset, click on the
d to confirm your decision. Once the reset process is complete
s Point again.
53
you