Unpacking And Assembly; Unpacking; Assembly; Attaching The Front Handle - Oregon ST250 Manual De Instrucciones

OREGON® Cordless Tool System
TRIMMER/EDGER MODEL ST250

UNPACkING AND ASSEMBLY

UNPACkING

WHAT'S IN THE BOx?
The trimmer/edger requires some
assembly before use These items ship
with the trimmer/edger:
• Trimmer/Edger
• Front handle
• Front handle adjustment knob
• Guard with attachment screw
• Instruction manual
• Charger and power cord (if so equipped)
• battery (if so equipped)
After removing the trimmer/edger
from the box, inspect it carefully to
ensure no damage has occurred during
shipping and that no parts are missing
If any parts are damaged or missing,
do not use the trimmer/edger Contact
OREGON® Cordless Tool System to obtain
replacement parts at 888 313 8665
AF 0513 - F/N 558937
uNpACKiNg AND ASSEMBLY

ASSEMBLY

WARNING: REMOVE THE BATTERY
PACk FROM THE TRIMMER/EDGER
BEFORE ATTACHING THE GUARD
AND FRONT HANDLE. A BATTERY
OPERATED TOOL WITH THE BATTERY
PACk INSERTED IS ALWAYS ON AND
CAN START ACCIDENTALLY.
WARNING: DO NOT OPERATE
THE TRIMMER/EDGER WITHOUT
THE FRONT HANDLE AND GUARD
ATTACHED.

ATTACHING THE FRONT HANDLE

The front handle fits on the shaft at a
comfortable distance between the rear
handle and the trimmer motor housing
(Fig 4)
• Grip the front handle near the clamping
point (1)
• Snap the front handle onto the shaft
so that the clamp is nearest the rear
handle (2)
• Insert the front handle adjustment knob
through the hole on the front handle (3)
and tighten
Fig. 4
(1)
(3)
(2)
13