Basic Operation; Turning On The Cbx-300; Adjusting The Volume; Selecting The Input Source - Onkyo CBX-300 Manual De Instrucciones

Basic Operation

STANDBY/ON
STANDBY indicator
(front panel)

Turning On the CBX-300

CBX-300
To turn on the CBX-300, press the [STANDBY/ON] but-
ton on the CBX-300 or remote controller. The
STANDBY indicator goes off.
Press the [STANDBY/ON] button again to set the
CBX-300 to Standby. The STANDBY indicator lights
up.

Adjusting the Volume

CBX-300
Press the VOLUME Up [
ume or the VOLUME Down [
You can also use the remote controller's VOLUME
[ ]/[ ] buttons.
The adjustable range is: Min, 1 through 43*, Max.
*Depending on the Maximum Volume setting, this value
can be 43 through 49 (see page 48).
20
En-
PHONES
(rear panel)
VOLUME INPUT
Remote
controller
Remote
controller
] button to increase the vol-
] button to decrease it.
STANDBY/
ON

Selecting the Input Source

You can select CD, iPod, FM, AM, or LINE, which can
be an external component.
To select the input source, press the remote controller's
INPUT [ ]/[ ] buttons repeatedly. On the CBX-300,
press the [INPUT] button repeatedly. The input sources
are selected in the following order.
CD iPod

Using Headphones

Turn down the volume, then connect your stereo head-
phones to the PHONES minijack.
You can adjust the volume and mute the sound as nor-
mal.
The speakers output no sound while the headphones are
connected.
PHONES jack
INPUT
/
VOLUME
/
FM AM LINE