Milwaukee 2790-20 Manual Del Operador página 5

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Warning
charger specified for the battery. For specific
charging instructions, read the operator's
manual supplied with your charger and
battery.
Inserting/Removing Battery Pack
Turn the compartment latches to unlock and
open the battery/auxillary compartment.
Insert the battery pack by sliding it into the ap-
propriate battery bay.
To remove the battery pack, pull the battery pack
off of the bay.
V18
V28
12-18V
NiCd
Battery Indicator
When the radio is powered by a battery pack, the
battery indicator is displayed.
Battery pack installed
Charge battery pack/Battery pack not installed
Battery Pack Protection
To protect the life of the battery pack, the radio will
shut off when the battery's charge becomes too
low. If this happens, remove the battery pack and
charge it according to the charger's instructions.
Installing an Auxiliary Device
Open the Auxiliary Compartment to connect an
MP3 player, CD player, or other audio device using
the stereo auxiliary jack. Small devices (less than
2.5" wide, 5" high, and 5/8" thick) can be stored in
the compartment during use.
Warning
pack before changing or removing acces-
sories. Only use accessories specifically
recommended for this radio. Others may be
hazardous.
Warning
or electric shock, do not expose this radio to
rain or moisture.
Recharge only with the
M12
Always remove battery
To reduce the risk of fire
assembly
USB Power Outlet
This jack can be used to charge a cell phone, power
a CD player or any other device that uses less than
500 mA of DC electrical current. Charging will only
occur when the radio is plugged into an outlet. USB
Power Outlet will not charge when the radio is run-
ning off of a battery pack.
NOTE: Any device that uses more than 500 mA of
DC electrical current will trip a self-resetting function
and disable the output.
Warning
cals or may explode if used incorrectly. The
following care should be taken to prevent
such an incident:
• Make sure the positive (+) and negative (-)
M18
battery terminals are positioned correctly.
• Do not mix new and old batteries together,
or mix different types of batteries.
• Do not try to recharge non-rechargeable
batteries.
If chemicals from the batteries come in
contact with your skin, wash them off imme-
diately with water. If chemicals leak onto the
radio, clean the radio completely.
Changing Back-up Batteries
To hold station presets and clock time when the
battery pack is removed and the radio is unplugged,
2 AA batteries are required.
1. Remove battery pack and
unplug radio.
2. Remove the screw and battery
cover.
3. Insert two (2) AA batteries
according to matching positive
(+) and negative (-) marks.
4. Replace the battery cover and
screw.
operaTion
Turning On/Off
Plug the cord into an appropriate AC outlet or install
a suitable battery pack.
Press the Power
off. The radio station (frequency) is displayed. To
display the time, press the CLOCK button.
Volume
Use the
To instantly silent the radio, press the MUTE but-
ton. To return to the set volume, press the MUTE
button again.
5
Output wiring is
center positive
Batteries may leak chemi-
button to turn the radio on and
to increase or decrease the volume.

Publicidad

Tabla de contenido
loading

Tabla de contenido