Technical Specification - EGAmaster 610NM Manual De Instrucciones

ENGLISH
For screws and bolts up to
Tightening torque Mt (hard thread)
Air consumption, approx.
ID of hose (min.)
Service life and performance of the impact wrench are determined by:
a) The degree of air purity
b) The lubrication and maintenance
at a) Blow the air hose clear before connecting it to the machine. Install dirt and water separator
upstream of the machine, if it is not possible to prevent the formation of rust and water
condensation in the air distribution lines.
at b) Use always acid- and resin-free SAE 5W - SAE 10W oil. Thick flowing oil will stick the
vanes and affect the start-up and the performance of the machine. Only proper maintenance can
ensure constant performance, reduction in wear und thus, a decrease in operating costs and
increase in service life.
Observe the comments in the supplementary sheet.
"Maintenance of Pneumatic Tools"
In winter, or if the compressed air is very moist, an antifreeze lubricant, e.g. "BP-Energol AX
10", "Kilfrost" or "Kompranol N 74" should be used.
Check the oil level at the beginning of each shift (line oiler or screwed-on). After 60 service
hours check the lubricant in the impact mechanism and in the antifriction bearings and refill if
necessary.
8

TECHNICAL SPECIFICATION

At an operating / flow pressure of p = 6 bar
Square Drive
Socket size
Torque
Air connection
Weight
OPERATION INSTRUCTION
½"
M 20
17-30 mm
540 Nm (280 Nm)
610 Nm
0.32 m³/min.
10 mm
R 1/4" i
3.6 kg