Using Your Switch; Powering Up The Systems - Belkin F1DK102P Manual De Usuario

P74242ea-F1DK102P-man.qxd 01-04-2003
INSTALLATION
Connecting the Computer
1. Using the attached cables, take the VGA cable and connect it to
the VGA port on the first computer.
2. Connect the PS/2 keyboard KVM cable to the keyboard port on
the computer.
3. Connect the PS/2 mouse KVM cable to the mouse port on
the computer.
Repeat Steps 1 through 3 for the additional computer to be connected to
the Switch.
16:19 Page 6
6

USING YOUR SWITCH

Powering Up the Systems

Once all cables have been connected, power up your CPUs that are attached to
the Switch. All computers can be powered on simultaneously. The Switch
emulates a mouse and keyboard on each port and will allow your computer to
boot normally. Your Switch should now be ready for use.
You can select which computer to operate through hot key commands. Note that
it will take 1-2 seconds for the video to display after switching. This is due to
the refresh of the video signal. A re-synchronization of the mouse and keyboard
signal also takes place. This is normal operation and ensures that proper
synchronization is established.
You can conveniently change ports on the Switch through a keyboard command
sequence using the "SCROLL LOCK" key and up and down arrow keys. To send
commands to the Switch, press the "SCROLL LOCK" key twice within two seconds.
You will hear a beep for confirmation. Then you can press the up or down arrow
keys to switch between ports.
Switch to next active port,
up arrow
7
Switch to previous active port,
down arrow