Installation Instructions - NEO FOLLOWER 15R Manual De Usuario

Installation Instructions

4.1) Installing or replacing the lamp
Before replacing the lamp let the lamp cool down, because
during operation, the lamp can reach very high temperature.
During the installation of halogen lamps do not touch the
glass bulbs bare handed. Always use a cloth to handle the
lamps during insertion and removal.
Do not install lamps with a higher wattage. They generate
higher temperatures than which the device was designed for.
For the installation, you need one: PLATINUM 15R
Procedures:
1) Unscrew the 3 screws (A, B, C) on the bottom of the hous-
ing, holding the plate where the lamp is underneath. Careful-
ly remove the metal plate.
2) Insert the lamp counter-clockwise 35 degree into the lam-
pholder, then turn clockwise 35 degree to put it into the right
position. Attention: please wrap the lamp with the soft cloth
that comes with the packing, avoid naked hand contact to
the lamp directly.
NEO FOLLOWER 15 R
ENGLISH VERSION
Only install the lamp with the device unplugged from the mains.
CAUTION
3) Put the lampholder back position after install the lamp,
tighten the screw and complete the installation.
Please remember the lamp is not a hot-restrike type, you
must wait for approximately 10 minutes after having turned
off the lamp before you can turn it back on again.
p. 7