Cleaning And Maintenance - NEO FOLLOWER 15R Manual De Usuario

Instruction: profile according to silkscreen instruction.
5.2 Beam angel adjustment instruction
adjust beam angle: linearly adjusting
beam angel from 5° to 10°
Instruction: move sliders on both sides to focus and zoom.
(Attn: must keep both sides move to same value )

6. Cleaning and maintenance

The following points have to be considered during the in-
spection:
1) All screws for installing the devices or parts of the device
have to be tightly connected and must not be corroded.
2) There must not be any deformations on the housing, col-
or lenses, fixations and installation spots (ceiling, suspen-
sion, trussing).
3)The electric power supply cables must not show any dam-
age, material fatigue or sediments. Further instructions de-
pending on the installation spot and usage have to be ad-
hered by a skilled installer and any safety problems have to
be removed.
In order to make the lights in good condition and extend the
life time, we suggest a regular cleaning to the lights.
1) Clean the inside and outside lens each week to avoid the
weakness of the lights due to
accumulation of dust.
2) Clean the fan each week.
3) A detailed electric check by approved electrical engineer
each three month, make sure that
the circuit contacts are in good condition, prevent the poor
contact of circuit from overheating.
We recommend a frequent cleaning of the device. Please use
a moist, lint- free cloth. Never use alcohol or solvents.
There are no serviceable parts inside the device except for
the lamp. Please refer to the instructions under "Installa-
tion instructions".
NEO FOLLOWER 15 R
ENGLISH VERSION
Should you need any spare parts, please order genuine parts
from your local dealer.
p. 9