Identification Plate - Rivacold STH009 Manual De Uso Y Mantenimiento

DANGER:
ATTENTION:
3.9. Machine Data and Technical features
3.9.1.

Identification Plate

A suitable EC machine identification tag is mounted on the machine identifying the following, and must also be stated in all
communications with the manufacturer regarding servicing and/or spare part requests. It is located on the condensing unit
(Picture 2).
Information listed:
code,
serial number,
amps (A),
Watts (W),
refrigerant type,
power supply voltage (Volt/Ph/Hz),
maximum working pressure PS HP (high pressure side) - PS LP (low pressure side),
maximum working pressure TS HP (high pressure side) - TS LP (low pressure side),
system category according to Directive 97/23 / EC (PED).
Identification of the Serial Number
figure 1 and 2 = the two last figures of the construction year,
figure 3 and 4 = the week of the year in which the machine was built,
figures 5, 6, 7 and 8 = sequential number.
set
on
off
3.10 Technical Data and Overall Dimensions
The technical features of the machine are found in Chapter 9 – Attachments in this handbook.
C h a p t e r 4
C h a p t e r 4
T r a n s p o r t a
T r a n s p o r t a
4.1. General information
The installation and possible re-installation of the machine must be conducted directly by qualified staff.
Before proceeding to installing the machine, it is necessary to prepare the power supplies and utilities necessary for the correct
functioning of the system, following the indications reported in this chapter and, if necessary, consulting the manufacturer's
Technical Office in advance.
ATTENTION:
DANGER:
4.1.1. Power and Utilities
The power supplies and utilities necessary (responsibility of the purchaser) for machine functioning exclusively consist in the supply
of electrical energy.
Unless otherwise indicated, the purchaser is responsible for:
the preparation of transport vehicles to transport the machine to the assembly or installation location;
tampering or unauthorised replacement or one or more parts of the machine and use of accessories,
tools or consumable materials other than those indicated by the manufacturer can generate danger of
injury.
all the materials with environmental impact which must be eliminated after interventions or processes
on the machine must be disposed of according to norms in force. If necessary, entrust specialist
structures to dispose of them.
Picture 2 – Position of the identification plate CE.
Label
Etichetta
n d I n s t a l l a t i o
n d I n s t a l l a t i
This product as sold complies with the 97/23CE (PED) standard and is marked with the relevant
category. After purchase it is the responsibility of the owner to ensure that this equipment is regularly
maintained continue its compliance up to the stage when it is finally decommissioned according to the
relevant national law.
the manufacturer declines all responsibility for any damage to property and/or persons deriving from
improper interventions conducted by unqualified, untrained or unauthorised staff.
n
o n
Etichetta
Label
ST-SP Pag. 45 Rev 00 02/10
UK