Using The Charger For The First Time; Working Display - Multiplex POWER PEAK QUAD EQ-BID 230V Instrucciones De Uso

Power Peak® Quad EQ-BID 230 V
5.

USING THE CHARGER FOR THE FIRST TIME

Connect the charger to a 230 V 50 Hz mains socket.
The menu language can now be selected from this display. The available languages can
following options available:
Language selection must be concluded by pressing the ENTER button. The start display
shown above will then appear.
5.1

WORKING DISPLAY

This display provides the user with all the necessary information during a charging or
discharging operation. The upper line of the status display shows the type of operation
Status indicator
Capacity indicator
Current battery
Battery
voltage
type
tant parameters at a glance during a charging or discharging operation.
Operating Instructions
ton is pressed and held while connecting the supply
voltage. This can be
button is pressed and held while connecting the sup-
ply voltage.
set separately for each charger.
(C for charging, D for discharging, F for
Time
finish and alternately C/B for balancing
elapsed
lithium batteries). The charged or dischar-
ged capacity and the time elapsed since
the start are also shown on the top line.
The type of battery (NC for nickel-cadmium
battery, NM for nickel-metal battery, LP for
Charge or
lithium-polymer battery, Li for lithium-ion
discharge
battery, LF for lithium-ferum battery and
current
Pb for lead battery) is shown on the bottom
line. The display therefore shows all impor-
8
32
# 30 8196
-