Warranty / Limits Of Responsibility - tbs electronics Powersine PS200-12 Manual Del Propietário

PROBLEM : 'Inverter temperature too high. Cooling down' error keeps on appearing
Possible cause :
Airflow around the inverter is obstructed
Too high ambient temperature
Note : Don't turn off the inverter when it's operating in an 'Inverter temperature too high. Cooling
down' error. The inverter needs this error time to cool down.
PROBLEM : Inverter jumps between continuous mode and ASB mode all the time
Possible cause :
Connected load is not compensated or the
ratio between inrush current and
continuous current is too large.
If none of the above remedies will help solving the problem you encounter, it's best to
contact your local TBS distributor for further help and/or possible repair of your inverter.
Do not open the inverter yourself, there are dangerous high voltages present inside.
Opening the inverter will directly void your warranty.

4. WARRANTY / LIMITS OF RESPONSIBILITY

TBS Electronics (TBS) warrants this inverter to be free from defects in workmanship or
materials for 24 months from the date of purchase. During this period TBS will repair the
defective inverter free of charge. TBS is not responsible for any costs of the transport of
this inverter.
This warranty is void if the inverter has suffered any physical damage or alteration, either
internally or externally, and does not cover damage arising from improper use
attempting to operate the inverter with excessive power consumption requirements, or
from use in an unsuitable environment.
This warranty will not apply where the product has been misused, neglected, improperly
installed or repaired by anyone other than TBS. TBS is not responsible for any loss,
with this inverter
Remedy :
Make sure there is at least 10 centimeters
of clearance around the inverter. Remove
any items placed on or over the inverter.
Keep the inverter away from direct sunlight
or heat producing equipment
Move the inverter to a cooler place or
provide additional cooling by an external
fan
Remedy :
Connect an additional load to the output.
14
1)
,