Sound Control - Panasonic CQ-C3405U Manual De Instrucciones

General
 Up
 Down
Setting Range: 0 to 40
Default: 18
Volume off (down)
Press [MUTE].
Cancel
Press [MUTE] again.
Note: You can select mute or attenuation.
The source changes as follows every time [SOURCE]
is pressed.
AUX1 (AUX1 in) (3.5 mm  stereo)
From line output of external sound/audio device (ex.
Silicon-audio player, HDD player, etc.)
Radio
FM1, FM2, FM3, AM ( page 14)
Player
When loading CD ( page 16)
When loading MP3/WMA disc ( page 18)
AUX1
Device connected to the AUX1 terminal of this unit
12
CQ-C3405U/C3305U
Note: The volume level can be set independently for
each source. (For radio, one volume setting for AM, one
volume setting for all FMs)
Caution
• Set the volume level to low enough before the
AUX connection is completed.
( page 23)
Failure to observe this, the loud noise may come
out and damage your speakers and your hearing.
System-up Connector
When an optional device is connected:
Shift to connected device
When connecting CD changer
When connecting iPod
When connecting XM Receiver
When connecting Sirius Receiver
OR
When an expansion module is connected:
The devices connected to the ports 1 to 4 are
activated in sequence after shifting to AUX2 (device
connected to the AUX terminal of the expansion
module).
Note: For information about connectable devices,
refer to the System Upgrade Guidebook or the
instruction manual for each device.

Sound Control

The equalizer curve is selectable from among 4 types
(FLAT, ROCK, POP and VOCAL) depending on your
listening category.
SQ changeover
The SQ category is changed every time [SQ] (Sound
Quality) is pressed.
(FLAT) fl at frequency response:
does not emphasize any part.
(Default)
(ROCK) speedy and heavy sound:
exaggerates bass and treble.
(POP) wide-ranged and deep sound:
slightly emphasizes bass and treble.
(VOCAL) clear sound:
emphasizes middle tone and slightly
emphasizes treble.
Press [DISP] to return to the regular mode.
Notes:
• Setting of SQ, bass/treble and volume are infl uenced
one another. If such an infl uence mentioned above
causes distortion to the audio signal, readjust bass/
treble or volume. ( page 22)
• Please refer to page 22 for the adjustment to each
speaker and an optional subwoofer.
· Bass adjustment
· Treble adjustment
· Balance adjustment
· Fader adjustment
· Subwoofer level adjustment
13
CQ-C3405U/C3305U